Industrial Control System Diagram Symbols
Edraw software provides you lots of transmission path shape, wire, multi-lines bus, multi-lines bus elbow, straight bus, elbow bus, junction, various junction, terminal, terminal list, terminal block, terminal 3-phase, test point, label, transmission path, left direction, right direction, outware flow, inware flow, underground cable, etc.
Industrial Control System Diagram Symbols
Industrial Control System Diagram Shapes
Wire is a metal drawn out into the form of a thin flexible thread or rod.
Junction is a point where two or more things are joined.
Terminal is a point of connection for closing an electric circuit.
Terminal block is a device that joins wires or cables. Terminal blocks typically snap into a metal rail or are screw mounted on the panel of a control enclosure.
Test point is a location within an electronic circuit that is used to either monitor the state of the circuitry or to inject test signals.
Underground cable is cable that is intended to be placed beneath the surface of the ground in ducts or conduit. Not necessarily intended for direct burial in the ground.
Submarine cable is a cable designed to be laid underwater.
Loaded cable generally means the final cable before the actual load.
Inductor is a component in an electric or electronic circuit which possesses inductance.
Choke in electronics is an inductor used to block higher-frequency alternating current.
Variometer is an inductor whose total inductance can be varied by altering the relative position of two coaxial coils connected in series, or by permeability tuning, and so usable to tune an electric circuit.
Transductor is type of magnetic amplifier used in power systems for compensating reactive power.
Need fresh looking industrial control system diagram symbols for your design? These industrial control system diagram symbols are a cinch to pop in. And their crisp, fine detail will make spectacular, easy-to-understand diagrams and presentations to your customers.
More Resources:
